Skip to main content
Simple registration for the technical inspection
QUALITY MADE IN GERMANY
DIRECT FROM THE MANUFACTURER
WORLD'S NR.1 TUNING ADAPTER
15 YEARS OF EXPERT KNOWLEDGE
FREEDOM: INSTALL WHAT YOU WANT
Simple registration for the technical inspection
QUALITY MADE IN GERMANY
DIRECT FROM THE MANUFACTURER
WORLD'S NR.1 TUNING ADAPTER
15 YEARS OF EXPERT KNOWLEDGE
FREEDOM: INSTALL WHAT YOU WANT
Simple registration for the technical inspection
QUALITY MADE IN GERMANY
DIRECT FROM THE MANUFACTURER
WORLD'S NR.1 TUNING ADAPTER
15 YEARS OF EXPERT KNOWLEDGE
FREEDOM: INSTALL WHAT YOU WANT

Thin shorter drive shaft VW Golf 7 8 Skoda Audi Seat Joint set axle joint 111.016.007SP VW 5Q0407272DN

  • ✓ Front axle
  • ✓ Golf 7, Golf 8, Audi 83, Seat
  • ✓ OE number VW 5Q0407272DN, CEVAM 50834

10mm shorter thin drive shaft for many VW and Seat models. Essential if you want to lower your vehicle! The shafts are 30 mm thick, are made from a single piece of high-strength steel and are solid shafts, making them suitable for higher-performance engines.

With our significantly thinner and extremely stable drive shaft, you can avoid the common problem of the drive shaft hitting the body when the vehicle is lowered.

It is important that no excess pressure is created in the sleeve when installing the new drive shaft. You can see how to prevent this in our installation instructions (click here)

Installing the thinner drive shaft saves you having to rework the body, which saves you time and nerves.

OE Number

  • VW 5Q0407272DN
  • CEVAM 50834
  • MEYLE 100 498 0757
  • NTY NPW-VW-083
  • SKF VKJC 4206

Scope of delivery:

  • 1x thin drive shaft shortened / solid shaft, including joint set / axle joints for Golf 7,8, Audi A3, Seat, ...
Our drive shafts are registration-free and therefore do not need to be registered.

Technical data:

Mounting location: front
Mounting location: front

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


  • What exactly is the point of having a shorter driveshaft?
  • As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.

  • Do reinforced driveshafts also have reinforced ball joints ?
  • The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.

  • Why are two bags of grease included in the delivery?
  • The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done. 

  • Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
  • We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.

Questions? Click here for the contact form
slide 1 to 3 of 3