Right Thinner and Shorter Drive Shaft VW Golf Mk5 Mk6 GTI Special Manual Gearshift DSG Vehicles Passenger Side
- ✓ Front axle right
- ✓ Golf 5, Golf 6 GTI
- ✓ manual switch and DSG transmission
€357.64*
- TÜV registration free
- 15 years expert knowledge
- shipping within 24h
- 2 years warranty
Right thinner and shorter drive shaft for all VW Golf Mk4 and Golf Mk5 GTI. Absolutely necessary if you have lowered your vehicle. The drive shaft set is suitable for manual gearshift and DSG vehicles.
It is important that when installing the new drive shaft, there is no excess pressure in the sleeve/gaiter. In our installation instructions you can see how to prevent thist (click here)
By installing the drive shaft, you save yourself the work on the body. This saves you time and nerves. Since the shafts are completely equipped with new joints, they can be installed immediately.
The diameter is 26mm less and 15mm shorter than the series shaft
Suitable for the following gearbox:
- DSG
Advantages of the drive shaft:
- stable up to 700 hp
- fit 100%
- solid shaft made of special high-strength material
- easy assembly
Delivery:
- 1x right thinner and shorter drive shaft for Golf Mk5 Mk6 GTI
Our drive shafts are registration-free and therefore do not have to be registered.
Login
- Does the driveshaft set also fit DQ250 transmissions of 6-cylinder engines?
No, our drive shaft set only fits DQ250 transmissions from 4-cylinder engines, as the DQ250 from 6-cylinder engines has a star-shaped flange, and therefore our joints would not fit, and also the DQ250 from 6-cylinder engines have a tripod joint instead of a constant velocity joint.
- What exactly is the benefit of a shorter drive shaft?
Lowering changes the axle geometry and the shaft presses on the wheel bearing, exposing it to high wear and possibly destroying it in the worst case. Therefore, it is absolutely necessary to relieve the pressure from the component. This is done by shortening the shafts.
- Do the reinforced drive shafts also have reinforced joints?
On the wheel side, the joints are also reinforced, but the inner joints are like the standard joints.
- Why are two bags of grease included in the package?
The grease is included so that additional greasing can be done, or if the gearbox flange is open at the back. In this case, greasing must still be done there. If the shaft is delivered completely closed, greasing is not necessary as it has already been done.
- Why are no backing plates (OE: 1K0407357D) included for mounting as they are originally available?
We do not supply the base plates, as we install the latest version of the bellows. With these, the base plates are no longer needed.
| Motor | Motorcode |
|---|---|
| 2.0 GTI | 5K1|235PS(173KW) |
| 2.0 GTI | 5K1|210PS(155KW) |
| Motor | Motorcode |
|---|---|
| 2.0 GTI | 5K1|235PS(173KW) |
| 2.0 GTI | 5K1|210PS(155KW) |