Drive Shaft VW Golf MK1 MK2 MK3 G60 VR6 Conversion 4 Motion 4WD Rear Axle
- ✓ all-wheel drive rear axle
- ✓ VW Golf 2, VW Golf 3, Passat, Corrado
- ✓ 02M, 02Q gearbox
€340.71*
- TÜV registration free
- 15 years expert knowledge
- shipping within 24h
- 2 years warranty
Drive shaft kit (without axle joint) for all VW Golf MK2 MK3, Passat und Corrado. Absolutely necessary, if you want to convert your vehicle to 4 Motion. The drive shafts at the rear have a length of 520 & 380mm (only shat measure).
It is important that when installing the new drive shaft, no excess pressure is created in the sleeve. In our installation instructions you can see how to prevent this (click here).
Advantages of the drive shaft::
- stable up to 1000 Nm torque
- fits plug and play
- solid shaft made of special high-strength material
- easy assembly
Delivery:
- 1x drive shaft kit (without axle joint) for VW Golf MK1, MK2, MK3, Passat and Corrado, stable up to 1000 HP
Technical data:
Login
2 February 2022 11:11
Marc Patrick B
Alles top
27 January 2021 19:01
Marcel R
Qualitativ hochwertig verarbeitet und das zu einem guten Preis
28 May 2019 19:16
Wilfried A
Sie halten bisher. Sehr passgenau und sauber verarbeitet.
19 February 2021 10:58
Patrick L
Alles top
24 August 2023 18:50
Christian M
Perfekt danke
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.