Skip to main content
Simple registration for the technical inspection
QUALITY MADE IN GERMANY
DIRECT FROM THE MANUFACTURER
WORLD'S NR.1 TUNING ADAPTER
15 YEARS OF EXPERT KNOWLEDGE
FREEDOM: INSTALL WHAT YOU WANT
Simple registration for the technical inspection
QUALITY MADE IN GERMANY
DIRECT FROM THE MANUFACTURER
WORLD'S NR.1 TUNING ADAPTER
15 YEARS OF EXPERT KNOWLEDGE
FREEDOM: INSTALL WHAT YOU WANT
Simple registration for the technical inspection
QUALITY MADE IN GERMANY
DIRECT FROM THE MANUFACTURER
WORLD'S NR.1 TUNING ADAPTER
15 YEARS OF EXPERT KNOWLEDGE
FREEDOM: INSTALL WHAT YOU WANT

Short Drive Shaft Transmission Shaft Front Left Golf MK1 Conversion VR6

  • ✓ Front axle left
  • ✓ Golf 1, Golf 1 Cabrio, Scirocco, VR6 conversion
  • ✓ Registration free

Suitable for the following vehicles:

  • Golf MK1 Cabriolet
  • Golf MK1
  • Scirocco
It is important that when installing the new drive shaft, no excess pressure is created in the sleeve. In our installation instructions you can see how to prevent this (click here).

Delivery:

  • 1x short drive / transmssion shaft, 1 cm shorter, inclusive axle joint,  for Golf MK1, etc

Our drive shafts are registration-free and therefore do not have to be registered.

Technical data:

Mounting location: front
Mounting location: front

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


  • What exactly is the point of having a shorter driveshaft?
  • As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.

  • Do reinforced driveshafts also have reinforced ball joints ?
  • The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.

  • Why are two bags of grease included in the delivery?
  • The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done. 

  • Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
  • We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.

Questions? Click here for the contact form
slide 5 to 7 of 8