Drive Shaft VW Golf Mk2 / Mk3 G60 VR6 R32 Conservion 4 Motion 02M 02Q 6-speed Narrow Axle 4WD
- ✓ Narrow axle
- ✓ Golf 2, Golf 3, Jetta 2, Seat Toledo
- ✓ 02M/02Q/ DQ250/DSG all-wheel drive transmission external joint VR6 fine teeth/G60 coarse teeth
€544.88*
- TÜV registration free
- 15 years expert knowledge
- shipping within 24h
- 2 years warranty
Drive shaft set for all VW Golf Mk2, Jetta 2 and Seat Toledo 1 with narrow axle. Absolutely necessary if you want to convert your vehicle to a VR6, 16V or 1.8T engine and 4 motion.
It is important that when installing the new drive shaft, there is no excess pressure in the sleeve/gaiter. In our installation instructions you can see how to prevent thist (click here)
By installing the drive shaft, you save yourself the work on the body. This saves you time and nerves.
Advantages of the drive shafts:
- unique and perfect fit especially for the above mentioned conversion
- stable up to 700 hp
- fit 100%
- solid shaft made of special high-strength material
- easy assembly
Delivery:
- 1x drive shaft set for VW Golf Mk2 Jetta 2 Seat Toledo 1 (narrow axle) up to 800hp
Our drive shafts are registration-free and therefore do not have to be registered.
Login
11 June 2020 07:48
Vitali S
Kann ich nur weiter empfehlen... Top
25 June 2020 08:43
Vitali S
Top
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.