VW Bus Transporter T2 T3 T4 Syncro Shaft Joint Screw Drive Shaft
- ✓ M10x50
- ✓ high-strength screw
- ✓ for cardan shaft
€0.59*
% €1.02* (42.16% saved)- Easy TÜV registration
- Quality Made in Germany
- Fair prices without middlemen you buy directly from the manufacturer and developer of the product
- Worldwide no. 1 in tuning adapters
- 15 years expert knowledge
- 10 years warranty
Size:
- thread: M10
- thread pitch: 1,5 mm
- length: 50,0 mm
- quality: 12,9 mm
- surface: blank
Delivery:
- 1x shaft joint screw for drive shaft on VW T2, T3 and T4 bus/transporter
Login
12 December 2019 20:57
Frank P
schnelle Lieferung, Qualität ist super.
9 November 2019 12:02
Martijn C
Super qualität, alles gute
25 June 2023 22:48
Olaf D
Alles top
9 November 2019 13:58
Martijn C
Super qualität, einfach gut!
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.