Drive Shaft VW Golf Mk2 Mk3 6-speed 02M 02Q VR6 Plus Axle/ VR6 Axle Front left
- ✓ VR6 plus axle front
- ✓ VW Golf 2, Golf 3, Jetta, Seat Toledo
- ✓ 02M/02Q 6-speed gearbox
€221.47*
- TÜV registration free
- 15 years expert knowledge
- shipping within 24h
- 2 years warranty
Drive shaft set for all VW Golf Mk2 and Golf Mk3 Jetta 2 Seat Toledo 1, plus axle VR6. Absolutely necessary if you want to convert your vehicle to a Vr6, 16V or 1.8T engine, combined with the 02M 6-speed gearbox.
We also have the right engine and gearbox mounting bracket, as well as the right adapters to convert the 02M 6-speed to front-wheel drive. Just have a look in our shop or below in the accessories.
It is important that when installing the new drive shaft, there is no excess pressure in the sleeve/gaiter. In our installation instructions you can see how to prevent thist (click here).
By installing the thin drive shaft, you save yourself the work on the body. This saves you time and nerves.
suitable for the following gearbox:
- 02M
- 02Q
Advantages of the drive shaft:
- stable up to 800 hp
- fit 100%
- solid shaft made of special high-strength material
- easy assembly
Delivery:
- 1x drive shaft for Golf Mk2 Golf Mk3 Jetta 2 Seat Toledo 1 (plus axle VR6 ), stable up to 800 hp
Our drive shafts are registration-free and therefore do not have to be registered.
Technical data:
Login
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.