Conversion Kit Drive Shaft Transmission Shaft VW Golf MK4 GTI 1.8T Jubi 6-Speed 02M Lowering
- ✓ Front axle right
- ✓ Golf 4 GTI, Golf 4 1.8 T
- ✓ Jubi 6-speed 02M 02Q gearbox
€276.73*
Name | Title | Surcharge |
---|---|---|
Chassis number: |
- 30 days money back guarantee
- shipping within 24h
- 15 years expert knowledge
- 2 years warranty
Fine thin drive / transmission shaft (10 mm shorter) with corresponding wheel hubs and wheel bearings for Golf MK4 GTI, Golf MK4 1.8 T Jubi 6-speed 02M 02Q gearbox.
Absolutely necessary when lowering! The shaft is made of high-strength steel and manufactured in one piece and is a complete drive shaft.
Thanks to our thin and extremely stable transmission / drive shaft, you avoid many problems at the body that usually appear during a chassis lowering. With the installation of our drive shaft, you avoid many modifications and you save time.
It is important that when installing the new drive shaft, no excess pressure is created in the sleeve. In our installation instructions you can see how to prevent this (click here).
Technical data:
assembly side | front axle right |
length | 796,0 mm |
thread | M20x1.5 |
drilling-Ø | 10,2 mm |
PCD-Ø | 94 mm |
joint diameter, gear side | 108 mm |
number of drill holes | 6 |
external toothing wheel side | 36 |
chassis | for vehicles with low-profile chassis |
joint diameter wheel side | 98,0 mm |
Delivery:
- 1x fine thin drive / transmssion shaft, 1 cm shorter, inclusive axle joint, wheel hub and wheel bearing, for Golf MK4 GTI, Golf MK4 1.8 T Jubi 6-speed gearbox
Our drive shafts are registration-free and therefore do not have to be registered.
Technical data:
Login
13 November 2021 07:32
Christian K
👍
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.