Installation instructions for article 698 02M conversion for installation in front-wheel drive cars e.g. VR6 conversion to 02M transmission
With this Epytec Tuning Adapter, you can easily convert the 6-speed 02M 02Q gearbox, which is normally intended for all-wheel drive, to front-wheel drive. The Epytec Tuning Adapter is not only needed to mount the shaft flange, but is also important to seal the oil line that is normally open for the angle drive.
First, the angle drive must be emoved from the 02M gearbox.
Afterwards, the existing toothed ring bearing must be removed as it is no longer needed.
Then insert the supplied sealing rings into the Epytec adapter plate.
Tipp!!
It is best to grease the ring a little bit so that it holds better in the grooves of the plate.
Now the drive shaft flange can be inserted into the plate and the plate mounted with all 4 screws.
Important!!
first screw all the bolts into the gearbox with a few turns of the thread, then align the drive shaft flange in the gear teeth and then tighten all 4 bolts in a criss-cross pattern.
Tipp!!
Use medium-strength threadlocker everywhere, of course, so that nothing can come loose due to the resulting vibrations :)
Do not use the 02M 4WD bolt to fix the flange, as they are too long. The 02m 2WD bolt must be used to secure the flange in the gearbox, e.g. installed in the TDI.
- ✓ 02M transmission conversion to FWD
- ✓ simple conversion
- ✓ Golf 1, Golf 2, 3, Golf 4 series