Right drive shaft VW Golf 1 Scirocco 1 Caddy Jetta joint set R32 VR6 axle joint
- ✓ Front axle right
- ✓ VW Golf 1, Caddy, Jetta
- ✓ VR6 or R32 conversion
€253.05*
Name | Title | Surcharge |
---|---|---|
Chassis number: |
- 30 days money back guarantee
- shipping within 24h
- 15 years expert knowledge
- 2 years warranty
Right shorter and thinner drive shaft for VW Golf 1, Scirocco 1, Jetta, Caddy, and many more models to convert them to VR6 or R32 engine. Absolutely necessary when lowering! The shafts are 26mm thick, made of high-strength steel and manufactured in one piece and are a complete drive shaft.
Suitable for the following vehicles when converted to VR6 or R32 with EPYTEC motor mounts/supports:
- Golf Mk1
- Scirocco 1 (53B)
- Jetta
- Caddy
Thanks to our thin and extremely stable transmission / drive shaft, you avoid many problems at the body that usually appear during a chassis lowering
It is important that when installing the new drive shaft, there is no overpressure in the sleeve/gaiter. In our installation instructions you can see how you can prevent this (click here)
With the installation of our drive shaft, you avoid many modifications and you save time.
Delivery:
- 1x thin shorter drive shaft / solid shaft including joint kit / axle joints VW Golf 1, Scirocco 1, Jetta, Caddy, and many more models to convert them to VR6 or R32 engine
Technical data:
Login
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.