Brake Caliper Adapter Audi S6 Porsche 993 Brake Caliper Audi S4 320x30mm Brake Disc

Brake caliper adapter on Audi S6 C4 model for conversion to Porsche 993 brake calipers, combined with the Audi S4 B5 320x30mm brake discs.

Suitable for the following vehicles:

• Audi S6 C4

A reference number and the EPYTEC logo is engraved on our caliper adapters. Thus, it is possible to register your purchase even for series vehicles, according §21 i.V.m. § 19/2 StVZO (German Road License Legislation).

Advantages

• high deceleration, also in conjunction with our rear axle braking system
• thanks to the material certificate supplied with the order, it is possible to register your purchase even for series vehicles
• directly fit to the above-mentioned models and therefore can always be restored to the original state without any problems
• Our EPYTEC brake caliper adapters do not require any sending of your serial parts, no welding, milling or drilling

Required components:

• brake calipers: Porsche 993 turbo , reference 993 351 426 , Brembo reference 20.5249.00
• brake discs: Audi S4 B5 320x30mm , reference 8E0615301AE
• brake pads: original 993 turbo 

Delivery:

• 2x brake caliper adapters for Audi S6 C4
• high strength mounting screws   
• material certificate

Notes/tips:

For a better ventilation of the brake system, we recommend removing the dust cover plates and brake anchor plate.

• install the adapter with the necessary components and then check if new brake lines are required. Because, depending on the vehicle, the lines may be too short or the line tips may not suitable. We advise you to change to steel braided brake line because of the quality and technical advantage. Specifically for this, we have developed an online brake line configurator, where you can assemble the type of steel braided brake lines you want. Click here to go to the configurator >> Stahlflex-Bremsleitung konfigurieren <<
• always use the hand brake cable of the installed brake caliper. So sometimes you have to modify / adapt the new handbrake cable. For conversions, where the original caliper is used and the handbrake cable can be used, you may need to pull the cable without any other fittings (ie directly) to compensate for the long distance due to the large diameter of the large brake discs.