Thin, shorter drive shaft VA left VW T5 T6 Bus 5-speed shifter16870HPS
- ✓ Front axle left
- ✓ VW T5 T6 Bus 5 speed shifter
- ✓ Registration free
€279.16*
- 30-day money-back guarantee
- dispatch within 24 hours
- 15 years of expert knowledge
- 2-year guarantee
shorter and thinner drive shaft for many VW models with 5-speed gearbox. Absolutely necessary when lowering! The shaft is made of high-strength steel, manufactured in one piece and is a complete drive shaft. Thus also suitable for high-performance engines
Thanks to our thin and extremely stable transmission / drive shaft, you avoid many problems at the body that usually appear during a chassis lowering
Please note that our short and thin drive shaft can be fitted to your vehicle if the distance from the centre of the wheel to the original mudguard edge is 31.5 cm or less. If this distance is greater on your vehicle, the shaft is too short and therefore not suitable for your vehicle
It is important that when installing the new drive shaft, there is no overpressure in the sleeve. In our installation instructions you can see how you can prevent this (click here)
With the installation of our drive shaft, you avoid many modifications and you save time.
Technical data:
assembly side | front axle left |
length | 633 mm |
thread | M20x1.5 |
drilling-Ø | 10,2 mm |
PCD-Ø | 94,6 mm |
joint diameter, gear side | 108 mm |
number of drill holes | 6 |
external toothing wheel side | 38 |
chassis | for vehicles with low-profile chassis |
for shaft diameter | |
joint diameter wheel side |
Application numbers:
- Multiparts 18-211410
- VW 7E0 407 271F
- VW 7H0407271AK
- VW 7H0407271E
- VW 7H0407271T
- VW 7H0407451JX
- VW 7H0407451X
Scope of delivery:
- 1x thin drive shaft shortened / solid shaft, including joint set / axle joints for VW T5, T6 Bus 5-speed shifter
Login
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.