1 cm Shorter Drive Shaft Left VW Golf MK5 MK6 Audi A3 Seat Toledo Skoda Octavia Axle Joint DSG
- ✓ Front axle left
- ✓ Golf 5, Golf 6, Audi A3, Seat Leon, Skoda
- ✓ Registration free
€291.61*
| Name | Title | Surcharge |
|---|---|---|
| Chassis number: |
- 30 days money back guarantee
- shipping within 24h
- 15 years expert knowledge
- 2 years warranty
1 cm shorter drive shaft for many VW and Seat models. Absolutely necessary when lowering! The shaft is 26mm thick, made of high-strength steel and manufactured in one piece and is a complete drive shaft. Thus also suitable for high-performance engines.
Suitable for the following vehicles:
- Golf MK5
- Golf MK6
- Golf Plus
- Eos
- Passat
- Touran
- Caddy 3
- Audi A3 ( 8P )
- Seat Altea
- Leon
- Octavia
Thanks to our thin and extremely stable transmission / drive shaft, you avoid many problems at the body that usually appear during a chassis lowering.
With the installation of our drive shaft, you avoid many modifications and you save time.
Important! Please note when installing that the axle boot is vented, otherwise it will inflate and burst.(click here)
Technical data:
| assembly side | front axle left |
| length | 470,0 mm |
| thread | M16x1.5 |
| drilling-Ø | 10,2 mm |
| PCD-Ø | 100 mm |
| joint diameter, gear side | 82,5 mm |
| number of drill holes | 6 |
| external toothing wheel side | 36 |
| chassis | for vehicles with low-profile chassisk |
| external diameter | 119,0mm |
| seal ring diameter | 59,5 mm |
| joint diameter wheel side | 98,0 mm |
Delivery:
- 1x 1 cm shorter drive shaft, left, inclusive axle joint, for Golf MK5, Golf MK6, Eos, Audi A3, Seat Leon, Octavia,...
Our drive shafts are registration-free and therefore do not have to be registered.
Technical data:
Login
30 July 2019 05:28
Christian S
Ein Muss beim Golf 6 GTD mit DSG wenn er sehr tief ist. Sehr schnelle Lieferung!! Alles top.
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.
- ✓ 28 teeth inside
- ✓ length: 64.1mm
- ✓ best quality
- ✓ 36 teeth on the outside
- ✓ 27 teeth on the inside
- ✓ best quality