Left Thinner and Shorter Drive Shaft VW Golf Mk5 Mk6 GTI Special Manual Gearshift DSG Vehicles
- ✓ Front axle left
- ✓ Golf 5, Golf 6 GTI
- ✓ manual switch and DSG transmission
€237.26*
- TÜV registration free
- 15 years expert knowledge
- shipping within 24h
- 2 years warranty
Left thinner and shorter drive shaft for all VW Golf Mk4 and Golf Mk5 GTI. Absolutely necessary if you have lowered your vehicle. The drive shaft set is suitable for manual gearshift and DSG vehicles.
It is important that when installing the new drive shaft, there is no excess pressure in the sleeve/gaiter. In our installation instructions you can see how to prevent thist (click here)
By installing the drive shaft, you save yourself the work on the body. This saves you time and nerves. Since the shafts are completely equipped with new joints, they can be installed immediately.
The diameter is 26mm less and 15mm shorter than the series shaft
Suitable for the following gearbox:
- DSG
Advantages of the drive shaft:
- stable up to 800 hp
- fit 100%
- solid shaft made of special high-strength material
- easy assembly
Delivery:
- 1x left thinner and shorter drive shaft for Golf Mk5 Mk6 GTI
Our drive shafts are registration-free and therefore do not have to be registered.
Technical data:
Login
- Does the drive shaft set also fit DQ250 transmissions of 6 cylinder engines?
No our driveshaft set only fits DQ250 transmissions of 4 cylinder engines, because the DQ250 of 6 cylinder engines has a star shaped flange and therefore our joints would not fit, and also the DQ250 of 6 cylinder engines also have a tripod joint, instead of a constant velocity joint.
- What exactly is the point of having a shorter driveshaft?
As a result of lowering, the axle geometry changes and the shaft presses against the wheel bearing, exposing it to high levels of wear and, in the worst case, destroying it. It is therefore imperative to depressurize the component. This is done by shortening the trees.
- Do reinforced driveshafts also have reinforced ball joints ?
The wheel-side ball joints are also reinforced, but the inner ball joints are like the standard ball joints.
- Why are two bags of grease included in the delivery?
The grease is included in the scope of delivery so that it can be regreased or if the gearbox flange is open at the rear. In this case, grease must still be applied there. If the shaft is supplied completely closed, no grease is required, as this has already been done.
- Why are no shims (OE: 1K0407357D) for the mounting supplied as they are original?
We do not supply the shims, as we install the latest version of the bellows. With these, the shims are no longer required.
- ✓ Front axle right
- ✓ Golf 5, Golf 6 GTI
- ✓ manual switch and DSG transmission
- ✓ Front axle left and right
- ✓ Golf 5, Golf 6 GTI
- ✓ manual switch and DSG transmission
- ✓ 28 teeth inside
- ✓ length: 32mm
- ✓ best quality
